Performance

Up to 1000 caps/min for single lane applications, depending on cap geometry and weight. Up to 1500 caps/min for multiple lane applications. For quotes with feed rate requirements, sample caps must be provided.

Structural

Formed stainless steel hopper and column with square stainless tubing for legs.

Mechanical

• Belt - 14 in (356 mm) width grey polypropylene
• Hopper - 20 ft³ (.57 m³); approximately 45 in (1143 mm) from floor to lip of hopper
• Discharge height - 90 in (2286 mm) standard
• Flights - CNC Machine PVC Standard. Stainless steel, conductive UHMW, or Delrin as required to achieve rates or to satisfy customer requirements
• Parts are discharged using medium pressure air from a regenerative blower; compressed air is not required

Electrical

• Power is 115 VAC single phase
• Belt motor is 230 VAC 3 phase with a variable frequency drive (115 VAC single phase input to drive)
• Start/stop switch and speed dial control
• "Track Full" sensor allows unit to be run independent of the machine it feeds
• Door switches shut down machine in the event unwanted material enters hopper
• NEMA 12 gray powder coated enamel enclosure

Options

• 10 ft³ (.29 m³); approximately 27.5 in (699 mm) from floor to lip of hopper
• Increased discharge height in increments of 12 in (305mm) to a maximum of 114 in (2896 mm)
• NEMA 4X (304 stainless steel) electrical enclosure
• 3/8 in (9.5 mm) Lexan hopper cover
• Belt cover and column top cover

---

Downloads

PDF Spec Sheet
2D CAD Footprint Drawing (AutoCad .dwg R2000)